GE JVM3162RJSS Installation Instructions Manual page 31

A4.
ADAPTING BLOWER FOR
OUTSIDE VENTILATION
(continued)
6 Place the blower unit back into the opening.
CAUTION
Do not pull or stretch the
blower unit wiring. Make sure the wires are
not pinched.
Reattach the cover plate on the back. Replace
6
blower plate and replace screws for blower plate
and blower motor removed in Step 1.
Blower Plate Screws
ASSEMBLE AND
A5.
INSTALL ADAPTOR
NOTE: On some models, the exhaust adaptor and
damper assembly may already be assembled to the
oven.
1
Place the oven in its upright position, with the top of
the unit facing up.
NOTE: Make sure the blower fan blades are
visible and are pointing up.
Insert the tabs on each side of the damper into the
2
holes at the inside rear of the adaptor.
31-7000173 Rev. 0
Installation Instructions
Blower Plate
Back of
Oven
Blower Motor Screw
Cover Plate
Damper
Exhaust
Adaptor
Blower Plate
Back of
Oven
Cover Plate
Attach the exhaust adaptor to the blower plate
3
with the two bronze metal screws provided.
Make sure that the damper pivots easily before
mounting oven.
You will need to make adjustments to assure
proper alignment with your house exhaust duct
after the oven is installed.
A6. MOUNT THE OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from over
tightening screws.
NOTE: When mounting the
oven, thread power cord
through hole in bottom
of top cabinet. Keep it tight
throughout Steps 1–3.
Do not pinch cord or lift
oven by pulling cord.
Rotate front of oven
up against cabinet
bottom.
1 Lift oven, tilt it
forward and hook
slots at back bottom
edge onto two lower
tabs of mounting
plate.
31