Table of Contents
Advertisement
Control terminal
MONITOR OUT
•
Connection to other display equipment for concurrent playback display.
•
PC
15-pin VGA port for connection to RGB, component HD source, or PC.
HDBaseT
•
Connect an Ethernet cable (Cat5/Cat6) from HDBaseT transmitter with high-definition video (HD),
RS232 control and LAN control.
•
DVI-D
Connection to DVI source.
•
HDMI 1
Connection to HDMI source.
•
HDMI 2
Connection to HDMI source.
•
LAN
For connection to RJ45 Cat5/Cat6 Ethernet cable to control the projector through a network.
•
USB 1.5A
Support 5V/1.5A output.
•
3D SYNC OUT
Connection to 3D IR sync signal transmitter.
•
3D SYNC IN
Connect 3D-sync in cable from a computer or an enabled device.
•
VIDEO
Connection to a video source.
•
SERVICE
Maintenance exclusive port for authorized maintenance personnel only.
•
RS-232 IN
Standard 9-pin D-sub interface for connection to PC control system and projector maintenance.
•
RS-232 OUT
Connects to another projector (same model) for RS-232 control.
•
PC 2 (R/Pr, G/Y, B/Pb, H, V)
Connection to RGB or YPbPr/YCbCr output signal with BNC type input terminal.
•
AUDIO IN (L/R)
Connection to an audio input source via an audio or audio L/R cable.
•
AUDIO OUT (L/R)
Connection to a speaker or headset.
•
AUDIO IN
Connection to an audio input source via an audio cable.
•
WIRED REMOTE IN
Connection to remote control for wire remote control.
•
WIRED REMOTE OUT
Connection to another projector.
•
12V TRIGGER
3.5mm mini earphone jack, employs 200mA display relay to provide 12(+/-1.5)V output and short
circuit protection.
Caution:
Make sure the port is valid before inserting a wired remote controller. The remote controller may be damaged in case
of an invalid port, e.g. a wired remote controller is connected to trigger output. For more information about upgrading
16
firmware via Lan, please contact BenQ service.
Advertisement
Table of Contents
