Table of Contents
Advertisement
Connect with projector
When you use a system with multiple projectors, use commercially available M3 stereo mini jack
cables to connect the other projectors via the WIRED REMOTE IN/WIRED REMOTE OUT
terminals.
The remote control is effective even in places where obstacles stand in the light path or where
devices are susceptible to outside light.
Note:
Use two core shielded cables no longer than 15 m (49.2 ft). The remote control may not operate when the length of
the cable exceeds 15 m (49.2 ft) or when it is not properly shielded.
Remote control effective range
Infra-Red (IR) remote control sensor is located on the front and rear of the projector. The remote
control must be held at an angle within 30 degrees perpendicular to the projector's IR remote
control sensor to function correctly. The distance between the remote control and the sensor
should not exceed 8 meters (~ 26 feet).
Make sure that there are no obstacles between the remote control and the IR sensor on the
projector that might obstruct the infra-red beam.
Approx. ±30°
Approx. ±30°
19
Advertisement
Table of Contents
