Table of Contents
Advertisement
Faults and what to do about them
en
Information on the display panel
Display
Õ
Hot
r
E lights up
The symbol Û
flashes
E:36
alternating with
-10
E:35
alternating with
-10 (Suitable for spe-
cial models)
H:95
alternating with
End
when programme is
finished
48
Cause/Remedy
Flashes fast + signal: The door was opened and the water level is too high.
■
Close the door, continue the programme with Start/Reload button or select
Drain.
Flashes slowly: The door lock temperature is too high to open the door. Wait
■
approx. 30 seconds until the door lock temperature cools down.
The temperature in the drum is too high. Wait for the appliance running to cool
down the laundry till the Hot disappears on the display panel, then the door can be
opened.
Flashes (no water supply): Water tap turned on? Filter in the water supply is
■
blocked? ~ "Filter in the water supply is blocked" on page 46
Is the supply hose kinked or trapped?
Lights up (low water pressure): For information only. This will not affect the
■
programme progress. The programme duration is extended.
The childproof lock is activated – deactivate it.
Run the Cottons 90°C programme to clean and care for the drum and the outer
tub.
Notes
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
■
only use half the amount of detergent recommended by the detergent manu-
facturer. Do not use detergent designed for woollens or delicates.
Switching the drum care information signal on/off. ~ Page 42
■
Drain pipe or water drain hose is blocked. Clean the drain pipe and the water
■
outlet hose.
Drain pipe or water drain hose is caught or jammed. Ensure that the drain pipe
■
and water drain hose are not kinked or trapped.
The drain pump is blocked.
■
~ "Drain pump is blocked" on page 44
The drain hose at the siphon is blocked.
■
~ "The drain hose at the siphon is blocked" on page 45
The water drain hose is connected too high. Install the water outlet hose at a
■
maximum height of 1 meter.
~ Page 17
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services.
No water detected in drying phase, may get bad drying result.
~ "Filter in the water supply is blocked" on page 46
Advertisement
Table of Contents
