Maintenance; Troubleshooting - Greenlee GATOR EK210 Instruction Manual

Battery-powered crimping tool
Table of Contents

Advertisement

Maintenance

Each Operating Day
Before use:
1. Inspect dies for wear or damage such as cracks,
gouges, or chips.
2. Inspect the tool for damage or leaks. If damage is
detected, return the tool to an authorized Greenlee
service center for inspection.
Skin injection hazard:
Do not use hands to check for oil
leaks. High pressure oil easily
punctures skin causing serious
injury, gangrene, or death. If injured,
seek medical help immediately to
remove oil.

Troubleshooting

Before You Begin
1. Make sure that the battery is charged. Recheck
the battery after several minutes to make sure the
battery is holding its charge.
Problem
Tool is inoperative.
Dies stop during operation.
LED glows for 20 seconds.
Tool loses oil.
Greenlee / A Textron Company
EK210 Battery-powered Crimping Tool
After use:
1. Wipe all tool surfaces clean with a damp cloth and
2. Fully retract the ram. Place the tool in the carrying
3. Charge the battery.
Monthly
Thoroughly clean all surfaces.
Annually or After 10,000 Crimps
Return the tool to an authorized Greenlee service center
for inspection.
2. Use a nonflammable contact cleaner or pencil
3. Reinstall the battery and check the tool again.
Probable Cause
Dirt, contaminants, etc., in ram area
of tool.
Crimping tool battery contacts
damaged.
Tool components worn or damaged.
Oil level is low.
Air in hydraulic system.
Battery charge low.
Damaged internal seal.
8
mild detergent.
Do not use solvents or flammable
liquids to clean the crimping tool.
Solvents or flammable liquids could
ignite and cause serious injury or
property damage.
case. Store in a cool, dry place.
eraser to clean the electrical contacts on the battery
and crimping tool.
Probable Remedy
Clean tool.
Reform contacts.
Return tool to an authorized
Greenlee service center.
Return tool to an authorized
Greenlee service center.
Pull trigger and hold retract button
simultaneously. Hold for approxi-
mately 10 seconds.
Charge or replace battery.
Return tool to an authorized
Greenlee service center.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070

Advertisement

Table of Contents
loading

Table of Contents