How To Set The Own Ship Position - Furuno FAR-1513-BB Operator's Manual

1. OPERATIONAL OVERVIEW
1.13

How to Set the Own Ship Position

You can select the data source for own ship's position as follows:
1. Place the cursor on the [OS POSN] box in the data display area, then press the
right button. The [OWN SHIP POSN] menu appears.
2. Select [NAV AID] or [MANUAL L/L] as appropriate, then push the ADJUST knob.
3. Select the appropriate setting, referring to the list below, then push the ADJUST
knob.
• [NAV AID]: Using navigational aids. Select the navigational aid in use. Available
options are: [GPS1], [GPS2], [LAN], [INS] or [DEAD RECKONING].
• [MANUAL L/L]: Manual input of own ship co-ordinates.
Note 1: Where [NAV AID] is set to [DEAD RECKONING], the indication "DR" ap-
pears at the bottom of the [OS POSN] box.
Note 2: Where [NAV AID] is set to [DEAD RECKONING] or [MANUAL L/L], the
AIS function cannot be used.
4. To set [MANUAL L/L], do the following:
1) Rotate the ADJUST knob to set the value.
2) Push the ADJUST knob to move the cursor to the next digit.
3) Repeat steps 1 and 2 to set the latitude and longitude.
5. To share [OS POSN] data across the same network, do the following:
1) Select [SIO DATA LAN OUTPUT], then push the ADJUST knob.
2) Select [ON], then push the ADJUST knob to share data. To disable [OS
POSN] data sharing, select [OFF], then push the ADJUST knob.
Note: A navigational aid must be selected at [NAV AID] to share [OS POSN]
across the same network.
6. Close the menu.
1-14