Greenlee 93-70 Operating, Maintenance And Safety Instructions page 6

3. Check that power is not present in system. Then connect the test leads to the 3-phase AC
circuit. Restore power to take reading.
4. One of the following results should appear on the display:
a. A right arrow symbol - the circuit is positive phase sequence.
b. A left arrow symbol - the circuit is negative phase sequence.
c. No arrow - the three phase circuit is only sending two phase voltage.
Temperature Measurement
1. Set the rotary selector switch to the F or C position.
2. Connect probe plug to Temperature Input Connector.
NOTE: Uses standard Type K thermocouple (NiCr/Ni) probes; see below for Greenlee probe
information.
3. Place probe tip in contact with item being measured. The temperature will appear on the
display.
Greenlee Temperature Probes (Type K, NiCr/Ni)
For use with 93-70 digital MultiTester and 93-1062 Digital Thermometer, plus other devices
using Type K probes.
Cat./UPC No. 5791/34558
Probe Tip
Application Pipe
Range F -58 - +572
( C) (-50 - +300)
To Measure Heat System
Temp. of Components
Response 5 sec.
Length or Max. Pipe Dia.
Capacity 1-3/8" (35 mm)
6
5792/34559 5793/34560
Air/Gas Semi-Solid
-58 - +1112 -58 - +1112
(-50 - +600) (-50 - +600)
Exhaust, Meats,
Fumes, etc. Foods, etc.
5 sec. 12 sec.
5" 5"
(130 mm) (130 mm)
5794-75TIP/34942 - Replacement Tip for 5794-75 Liquid Probe.
5794/34561 5794-75/34562 5795/34563
Liquid Liquid
-58 - +2012 -58 - +2012
(-50 - +1100) (-50 - +1100) (-50 - +450)
Water, Water,
Oil, etc. Oil, etc.
12 sec. 12 sec.
5" 29-1/2"
(130 mm) (750 mm)
Surfaces
-58 - +842
Stove Plates,
Heat Units, etc.
6 sec.
5"
(130 mm)