Table of Contents
Advertisement
2-4
Processor and Heatsink Installation
Warning: When handling the processor package, avoid placing direct pressure on
the label area. Also, improper CPU installation or socket/pin misalignment can cause
serious damage to the CPU or the motherboard that will require RMA repairs. Be sure
to read and follow all instructions thoroughly before installing your CPU and heatsink.
Notes:
•
Always connect the power cord last, and always remove it before adding,
removing or changing any hardware components. Make sure that you install
the processor into the CPU socket before you install the CPU heatsink.
•
If you buy a CPU separately, make sure that you use an Intel-certified multi-
directional heatsink only.
•
Make sure to install the motherboard into the chassis before you install the
CPU heatsink.
•
When receiving a motherboard without a processor pre-installed, make sure
that the plastic CPU socket cap is in place, and none of the socket pins are
bent; otherwise, contact your retailer immediately.
•
Refer to the Supermicro website for updates on CPU support.
Installing the LGA2011 Processor
1. There are two load levers on the LGA2011 socket. To open the socket cover,
first press and release the load lever labeled 'Open 1st'.
1
1
LGA2011-3
(LGA2011-3-Narrow)
Note: the graphics provided in the manual are for illustration only. Your
components may or may not look the same as the ones shown in this
manual.
Press down
on Load Lever
labeled 'Open 1st'.
2-7
Chapter 2: Installation
2
Advertisement
Table of Contents
