Table of Contents
Advertisement
Determing the Problem
Problem
Dryer does not start.
Start/Pause indicator
light does not illumi-
nate.
The display panel and
indicator lights switch
off, Start/Pause indica-
tor flashes.
The display panel and
Start/Pause indicator
switch off.
indicator lights up.
é
DR indicator lights up.
Water has not drained
completely.
Water is leaking out.
Program terminates
shortly after starting.
The door opens by
itself.
Creasing.
Possible cause(s)
Power cord end not inserted at all
or not inserted correctly.
A fuse is blown or breaker is
tripped.
Start/Pause button not pressed.
Door not closed properly.
Energy-saving mode is activated.
Automatic switch-off function is
active.
Lint filter dirty.
Heat exchanger dirty.
Drain hose is blocked.
Dryer is not leveled.
The heat exchanger seal is dirty.
Drain hose is leaking.
Laundry is not loaded.
Load too small for selected pro-
gram.
Loaded laundry is too dry.
The door not closed properly.
Laundry load exceeded.
Unsuitable program selected.
Solution(s)
Insert power cord end correctly.
Replace fuse or reset breaker.
Press Start/Pause button.
Check if laundry is caught in the door. Close the door
until a click is heard.
Press any button to activate the display.
~ Environmentally friendly use of your dryer; Page 9
Press the center of the Program Selector to switch on
the appliance.
Clean lint filter.
~ Cleaning the lint filter; Page 39
Press the Start/Pause button to reset the displayed
indication and then press Start/Pause button again to
reset the appliance if necessary.
Clean heat exchanger.
~ Cleaning the heat exchanger; Page 40
Press the Start/Pause button to reset the displayed
indication and then press Start/Pause button again to
reset the appliance if necessary.
Check drain hose.
~ Maintenance of drain hose; Page 41
Check drain hose connection conditions.
Level the dryer.
~ Leveling the dryer; Page 19
Clean the heat exchanger seal.
~ Cleaning the heat exchanger; Page 40
Check entire length of drain hose for leaks; replace if
necessary.
Check that hose is clamped on hose barb at back of
the dryer securely.
Load the laundry.
~ Loading the laundry; Page 29
Use time program.
~ Program selection; Page 28
~ Program selection table; Page 36
Check the loaded laundry. If it is dry, open the door,
remove laundry and press the center of the Program
Selector to switch off the appliance.
Close the door until a click is heard.
Do not exceed the maximum load for selected pro-
gram. Remove items of laundry immediately after the
end of the program, hang them up and pull into shape.
Press the center of the Program Selector to switch off
the appliance.
~ Program selection table; Page 36
Select Wrinkle Block™ button to prevent the laundry
from creasing or wrinkling.
~ Wrinkle Block™; Page 37
43
Advertisement
Table of Contents
