Table of Contents
Advertisement
Loading the laundry
WARNING
9
RISK OF EXPLOSION
Do not dry laundry that has ever been in contact
with solvents, oil, wax, grease or paint (e.g. hair
styling products, nail varnish remover, stain
remover, cleaning solvent, etc.).
Check lint filter.
1.
The filter should be cleaned after or before every
drying process. Cleaning the filter reduces the drying
time and saves energy.
~ Cleaning the lint filter; Page 39
Load the laundry into the drum and close the door.
2.
Tip: If the door has not been closed properly, the dryer
will not start.
Tips
After loading, close the door carefully so as not to trap
any items between the door and the rubber seal. The
door should be closed until a click is heard.
Foreign objects left in the drum may damage laundry.
Before inserting any laundry, check to make sure no
foreign objects are in the drum.
Recommended Load Size
Recommended maximum load size can be found in the
program selection table in this manual.
~ Program selection table; Page 36
Load the laundry
Place laundry in the empty drum. Put each piece of
laundry into machine separately.
For best results the laundry to be dried must be sorted
according to type of laundry and desired degree of
drying.
~ Sorting the laundry; Page 35
~ Program selection table; Page 36
~ Level Adjust; Page 37
Starting the program
Switch on the appliance. Rotate program selector to
1.
the desired program. Select the program which
corresponds to the laundry in the dryer from Program
selection table.
~ Program selection table; Page 36
The Start/Pause indicator light starts flashing.
Press the Start/Pause button. Indicator lamp lights up
2.
and the cycle starts.
During the cycle, the display area indicates the
estimated remaining time and, after starting the drying
cycle, the cycle duration and the symbols for the cycle
progress stay lit.
NOTICES
If you want to protect the cycle against inadvertent
▯
adjustment select the Child lock. ~ Child
lock; Page 38
If
indicator lights up, clean the lint filter and/or
é
▯
heat exchanger. ~ Cleaning the lint filter; Page 39,
~ Cleaning the heat exchanger; Page 40
If DR indicator lights up, check the drain hose and
▯
its connection. ~ Maintenance of drain
hose; Page 41
If required, select Low Heat by pressing the button.
3.
~ Low Heat; Page 37
If required, select Wrinkle Block™ by pressing the
4.
button. ~ Wrinkle Block™; Page 37
29
Advertisement
Table of Contents
