Access Point Default Settings; Backup And Restore Your Access Point Configuration Settings; Reboot Your Access Point - TRENDnet TEW-820AP User Manual

TRENDnet User's Guide

Access Point Default Settings

Administrator User Name
Administrator Password
Access Point Default URL
Access Point IP Address
Access Point Subnet Mask
Mode
Wireless
Wireless Network Name/Encryption
Wireless Multiple SSID

Backup and restore your access point configuration settings

Tools > Settings Management
You may have added many customized settings to your access point and in the case that
you need to reset your access point to default, all your customized settings would be
lost and would require you to manually reconfigure all of your access point settings
instead of simply restoring from a backed up access point configuration file.
To backup your access point configuration:
1. Log into your access point management page (see
management page" on page 8).
2. Click on Tools and click on Settings Management.
3. Next to Save Settings section, click Save.
© Copyright 2014 TRENDnet. All Rights Reserved.
admin
admin
http://tew-820AP
192.168.10.100
255.255.255.0
Access Point
Enabled
Please refer to sticker or
device label
Disabled
"Access your access point
4. Depending on your web browser settings, you may be prompted to save a file (specify
the location) or the file may be downloaded automatically to the web browser
settings default download folder. (Default Filename: config.bin)
To restore your access point configuration:
1. Log into your access point management page (see
management page" on page 8).
2. Click on Tools and click on Settings Management.
3. Next to Restore Configuration Settings, depending on your web browser, click on
Browse or Choose File.
4. A separate file navigation window should open.
5. Select the access point configuration file to restore and click Load. (Default Filename:
config.bin). If prompted, click Yes or OK.
6. Wait for the access point to restore settings.

Reboot your access point

Administrator > Settings Management
You may want to restart your access point if you are encountering difficulties with your
access point and have attempted all other troubleshooting.
There are two methods that can be used to restart your access point.
• Turn the access point off for 10 seconds using the access point On/Off switch
located on the rear panel of your access point or disconnecting the power port, see
"Product Hardware Features" on page 2. Use this method if you are encountering
difficulties with accessing your access point management page. This is also known
as a hard reboot or power cycle.
OR
• Access Point Management Page – This is also known as a soft reboot or restart.
TEW-820AP
"Access your access point
35