TRENDnet User's Guide
Access Point Maintenance & Monitoring
Reset your Access Point to factory defaults
Administration > Reset
You may want to reset your access point to factory defaults if you are encountering
difficulties with your access point and have attempted all other troubleshooting. Before
you reset your access point to defaults, if possible, you should backup your access point
configuration first, see
"Backup and restore your access point configuration settings"
page 25.
There are two methods that can be used to reset your access point to factory defaults.
• Reset Button – Located on the left side of your access point, see
Hardware
Features" on page 2. Use this method if you are encountering
difficulties with accessing your access point management page.
OR
• Access Point Management Page
1. Log into your access point management page (see
management
page" on page 9).
2. Click on Administration and click on Reset.
3. Click the Reset button to reset your access point to factory defaults.
© Copyright 2014 TRENDnet. All Rights Reserved.
on
"Product
"Access your access point
Access Point Default Settings
Administrator User Name
Administrator Password
Access Point IP Address
Access Point Subnet Mask
Wireless Interface
Wireless Network Name/Encryption
(WPA2-PSK AES)
Powerline Encryption Key
TPL-410AP / TPL-410APK
admin
admin
192.168.10.100
255.255.255.0
Enabled
Please refer to sticker or
device label
HomePlugAV
24