Table of Contents
Advertisement
12. Detach the junction box from the transceiver unit.
Transceiver unit
13. Loosen the two screws on the junction box, then slide the cover to open the box.
Connect the coaxial cable as shown below.
14. Close the junction box and tighten the screws. Reattach the box to the transceiver
unit.
15. Reconnect the plugs disconnected at step 2.
16. Set the transceiver module to the antenna unit and push the module in until it
stops. Tighten the fixing bolts. Be sure to push in the transceiver unit until it
stops. Failure to do so may cause microwave leakage.
17. Fasten the shield wire to the wing nut on the transceiver module.
18. Confirm that all screws are tightened and all wiring is properly made. Confirm that
the waterproofing gasket, bolts and tapping holes of the antenna unit are coated
with silicone grease.
19. Close the antenna unit cover.
Junction box
Coaxial cable
entrance
Position shield beneath clamp.
Fasten core.
2. WIRING
Fixing
screw
Core-fixing screw
Shield-fixing clamp
2-5
Advertisement
Table of Contents
