Table of Contents
Advertisement
Chapter 4 Using the TV menu
Sound Menu
The Sound Menu lets you adjust audio output. To access
the Sound Menu, press MENU on the remote, and then
use the up and down arrows (
the Main Menu. Press the OK button or right arrow key ( )
to select. The following options will be displayed:
Equalizer – The five-band equalizer allows you to adjust
the audio frequency settings. You can select one of the five
preset options or create a custom preset.
• Equalizer – Allows you to choose a specific
sound preset. Press the left and right arrows (
to cycle through the options: Standard, Movie, Voice,
Music and Personal.
• Frequency Range – Displays the different graphic
equalizer names set for each Sound Preset option.
Choose a band and make adjustments. When making
adjustments, the Sound Preset option automatically
changes to Personal. Press the left or right arrow
(
) to select the desired frequency (100Hz, 300Hz,
1KHz, 3KHz, 10KHz) you wish to adjust. Use the up
and down arrows (
have finished adjusting the levels, press the MENU
button to exit.
Balance – Use the left or right arrows (
amount of audio sent to the left and right speakers.
Surround – Option On/Off. When turned on, this option
enables a mode which simulates a surround sound effect.
Speaker – Option On/Off. When you select the Off option,
the sound speaker on the TV will be turned off.
SPDIF Type – Press the left or right arrow (
SPDIF type. This option controls the type of audio stream
sent to the Digital Audio Output jack. Available options are
Dolby Digital, PCM, or Off.
Auto Volume Control – This option reduced the annoying blasts in volume that often occur during
commercial breaks, and also amplifies softer sounds in program material, eliminating the need for
constant volume adjustment
Analog TV Sound – This option controls the manner in which the sound comes through your
speakers. Options available vary according to the input selected.
• Mono (available for regular TV viewing only) – This option plays the sound in mono only. Use
this setting when receiving broadcasts with weak stereo signals.
• Stereo – This option splits the incoming stereo audio signal into left and right channels. Most TV
programs and recorded materials have stereo audio. The word "Stereo" appears in the Channel
Banner when you tune to a program that is broadcast in stereo.
• Second Audio Program (SAP) – This option plays the program's audio in a second language,
if available. The letters "SAP" appear in the Channel Banner when you tune to a program that
is broadcast with SAP information. SAP audio is broadcast in mono only. SAP is also used to
broadcast a program's audio with descriptions of the video for the visually impaired.
) to highlight Sound from
) to adjust the level. When you
) to adjust the
) to select
Picture
Sound
Setup
Parental Control
Language
USB
Exit
)
Picture
Sound
Setup
Parental Control
Language
USB
Exit
22
Sound
Equalizer
Balance
Surround
On
On
Speaker
Dolby Digital
SPDIF Type
Auto Volume Control
Off
Stereo
Analog TV Sound
Enter
Back
Select
MENU
Sound
Equalizer
Balance
Surround
On
Speaker
On
SPDIF Type
Dolby Digital
Off
Auto Volume Control
Stereo
Analog TV Sound
Adjust
Back
Select
MENU
0
Exit
CLEAR
0
Exit
CLEAR
Advertisement
Table of Contents
