Connecting A Hdbaset Tm Equipment - Sony VLP-CH350 Operating Instructions Manual

Connecting a HDBaseT
For connecting the computer, video equipment, and network equipment via the HDBaseT
transmitter.
Connecting to the computer
INPUT D
Computer
Connecting to the video equipment
INPUT D
Video equipment
Notes for connecting this unit and the HDBaseT transmitter
• Ask a professional or Sony dealer to perform wiring. If wiring is not correct, the transmission
characteristics of the cable will not be achieved, and image or sound may break up or you may
experience unstable performance.
• Connect the cable directly to the HDBaseT transmitter without going through a hub or router.
• Use cables that meet the following conditions.
-CAT5e or higher
-Shielded type (covering terminals)
-Straight wire connection
-Single wire
• When installing the cables, use a cable tester, cable analyzer, or similar device to check if the
cables meet the CAT5e or higher requirement. If there is a transit terminal between this unit and
the HDBaseT transmitter, include it when measuring.
• To reduce the affect of noise, install and use the cable in a manner where it is not rolled up and it
is as straight as possible.
• Install the cable away from the other cables (especially the power cable).
TM
equipment
HDMI output
terminal
HDMI cable (not supplied)
HDMI output
terminal
HDMI cable (not supplied)
LAN cable: STP type (CAT5e or
higher, straight, not supplied)
HDBaseT transmitter
LAN cable: STP type (CAT5e or
higher, straight, not supplied)
HDBaseT transmitter
Connecting the Projector
13