Sony VLP-CH350 Operating Instructions Manual page 59

3
Loosen the 3 screws on the lamp (1)
then pull out the lamp by its grab (2).
4
Insert the new lamp all the way in until
it is securely in place (1). Tighten the
3 screws (2).
Note
Be sure to install the lamp and Lamp cover
securely as it was. If not, the projector
cannot be turned on.
5
Close the lamp cover and tighten the
3 screws.
6
Connect the AC power cord to a wall
outlet and turn on the projector.
7
Reset the lamp timer for
the next replacement time.
Select "Lamp Timer Reset" on the SET
SETTING menu then press the ENTER
key. When a message appears, select
"Yes" to reset the lamp timer (page 29).
Grab
Caution
For the customers in the
U.S.A. and Canada
mercury. Dispose according
to applicable local, state/
province and federal laws.
For additional information,
see www.sony.com/mercury
notification of
Lamp contains
Replacing the Lamp
59