Sony VLP-CH350 Operating Instructions Manual page 33

*10: This mode does not work for about three minutes after the lamp lights. A change in signal may
not be detected depending on the input image. The lamp may become brighter at intervals
during lamp dimming. However, this is not a malfunction. If With No Input is set, it takes
priority.
*11: Does not function when "Type B USB" or "Network" is selected as the input. In this case, it
becomes equivalent to "Standard." Cannot be selected by VPL-CH355/CH350.
*12: Constant Brightness mode will be enabled for about 2,000 hours after it is activated at early
usage. After this period, it will be disabled automatically. Activated time and brightness may
vary depending on the usage conditions.
*13: Select "Off" to avoid entering standby mode when there is no input signal.
*14: As the lamp is dimmed gradually, you may not notice any change in brightness. You might only
notice that the lamp has dimmed when its brightness is restored after there is a change in input
signal.
*15: Does not function when "Type B USB" or "Network" is selected as the input.
*16: This varies depending on the "Lamp Mode" setting.
*17: When "Standby Mode" is set to "Low," the network and network control function cannot be
operated while the projector is in standby mode.
The Connection/Power Menu
33