Maytag MVWB865GW Use And Care Manual page 15

TROUBLESHOOTING
First try the solutions suggested here or visit our website at producthelp.maytag.com.
If you experience
Washer not performing as expected (cont.)
Not enough water
in washer (cont.)
Washer won't run or fill,
washer stops working
or wash light remains
on (indicating that the
washer was unable to
fill appropriately)
If you experience
Washer not performing as expected (cont.)
Washer won't run or fill,
washer stops working
or wash light remains
on (indicating that the washer
was unable to
fill appropriately) (cont.)
Washer not draining/spinning,
loads are still wet, or spin light
remains on (indicating that the
washer was unable to pump
out water within 10 minutes)
In Canada www.maytag.ca for assistance and to possibly avoid a service call.
Possible Causes
Load not completely covered
in water. (cont.)
Check for proper water supply.
Possible Causes
Check proper electrical supply.
Normal washer operation.
Washer may be tightly packed.
Not using HE detergent or using too
much HE detergent.
Small items may have been caught
in pump or between basket and tub,
which can slow draining.
Solution
Run clean washer cycle to optimize the water level and
wash performance.
Both hoses must be attached and have water flowing to inlet
valve.
Both hot and cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not
interrupt cycle.
Washer may be stopped to reduce suds.
Remove several items, rearrange load evenly around the
agitator. Close lid, touch and hold the Start/Pause button.
Add only one or two additional garments after washer is started.
Do not add more water to the washer.
Only use HE detergent. Suds from regular detergents can slow
or stop the washer. Always measure detergent and follow deter-
gent directions based on your load requirements.
To remove suds, cancel the cycle. Select DRAIN & SPIN and
the Extra Rinse option. Touch and hold Start/Pause button. Do
not add more detergent.
Empty pockets and use garment bags for small items.
Solution
15