Maytag MVWB865GW Use And Care Manual page 11

8.
Select cycle
Turn the cycle knob to choose your wash cycle.
9.
Select Temperature
Light soils
Colors that
bleed or
fade
Once you select a cycle, select the wash temperature by
touching the Temperature button until you reach the desired
setting. Even for cold wash settings, some warm water may
be added to the washer to maintain a minimum temperature.
NOTE: Always read and follow fabric care label instructions
to avoid damage to your items.
10.
Select Soil Level
Once you select a cycle, select the soil level by touching
the Soil Level button until you reach the desired setting.
11.
Select Spin Speed
Once you select a cycle, you may adjust the spin speed
by touching the Spin Speed button until you reach the
desired setting.
Moderate Heavy
soils soils
Bright Whites
colors
Pastels
12.
Select cycle options, if desired
If you would like to add an Extra Rinse and/or Oxi option, touch
the button for that feature.
13.
Select Deep Fill mode, if desired
Once you select a cycle, you may disable the auto sensing
mode and turn on the Deep Fill mode by pressing the
Deep Fill button.
NOTE: Deep Fill is not available in the Normal cycle mode.
Selecting the Normal cycle with the Deep Fill setting will result
in auto sensing of the water level.
14.
Touch and the hold Start/Pause
button to begin wash cycle
Touch and hold Start/Pause for up to 3 seconds to start the
wash cycle. When the cycle has finished, the end of cycle signal
will sound (if set). Promptly remove items when the cycle is
done to avoid odor, reduce wrinkling, and rusting of metal hooks,
zippers, and snaps.
Unlocking the lid to add items
If you need to open the lid to add 1 or 2 missed items:
Touch Start/Pause button to pause washer; the lid will unlock
once the washer movement has stopped. This may take several
minutes if the load was spinning at a high speed. Then close
lid and touch and hold Start/Pause button again for up to
3 seconds to restart the cycle.
IMPORTANT: If lid is left open for more than 10 minutes the
water will pump out and F8E6 error code will appear on the
display.
11