Measuring At One Listening Position (Single Measure) - Yamaha MusicCast RX-V1083 Owner's Manual

AV AV
1 1 2 2 3 3 4 4
5 5 6 6 7 7 V-AUX V-AUX
AUDIO AUDIO
1 1 2 2 3 3 PHONO PHONO
TUNER TUNER BLUETOOTH BLUETOOTH USB USB NET NET
MAIN MAIN ZONE 2 ZONE 2 PARTY PARTY HDMI OUT HDMI OUT
SCENE SCENE
1 1 2 2 3 3 4 4
PROGRAM PROGRAM MUTE MUTE VOLUME VOLUME
TOP MENU TOP MENU POP-UP/MENU POP-UP/MENU
ON ON
OPTION OPTION
SCREEN SCREEN
Cursor keys
ENTER
ENTER
RETURN
RETURN DISPLAY DISPLAY
BAND BAND
MODE MODE
TUNING TUNING PRESET PRESET
SUR. DECODE STRAIGHT SUR. DECODE STRAIGHT
MOVIE MOVIE MUSIC MUSIC
ENHANCER PURE DIRECT ENHANCER PURE DIRECT
INFO INFO SLEEP SLEEP
1 1 2 2 3 3 4 4
5 5 6 6 7 7 8 8
9 9 0 0 MEMORY MEMORY ENT ENT
Measuring at one listening position
(single measure)
When "Multi Position" is set to "No", follow the procedure below for
measurement. It takes about 3 minutes to perform the measurement.
1
To start the measurement, use the cursor keys to select
"Measure" and press ENTER.
The measurement will start in 10 seconds. Press ENTER again to
start the measurement immediately.
X
To cancel the measurement temporarily, press RETURN.
The following screen appears on the TV when the measurement
finishes.
Y
If any error message (such as E-1) or warning message (such as W-1) appears, see
"Error messages" (p.49) or "Warning messages" (p.50).
X
To check the measurement results, select "Result". For details, see "Checking
the measurement results" (p.47).
2
Use the cursor keys to select "Save/Cancel" and press
ENTER.
3
To save the measurement results, use the cursor keys
(e/r) to select "SAVE" and press ENTER.
The adjusted speaker settings are applied.
X
To finish the measurement without saving the result, select "CANCEL".
4
Use the cursor keys (e/r) to select "YES" or "NO" to
enable/disable YPAO Volume and press ENTER.
X
• If YPAO Volume is enabled, the high- and low-frequency levels are
automatically adjusted according to the volume so that you can enjoy natural
sounds even at low volume.
• You can also enable/disable YPAO Volume in "YPAO Volume" (p.106) in the
"Option" menu.
5
Disconnect the YPAO microphone from the unit.
This completes optimization of the speaker settings.
Caution
The YPAO microphone is sensitive to heat, so should not be placed anywhere
where it could be exposed to direct sunlight or high temperatures (such as on
top of AV equipment).
45
En