Yamaha MusicCast RX-V1083 Owner's Manual page 108

■ Enhancer (Enhancer)
Enables/disables Compressed Music Enhancer and the high-resolution mode.
Enhancer (Enhancer)
Enables/disables Compressed Music Enhancer (p.68).
X
• This setting is applied separately to each input source.
• You can also use ENHANCER on the remote control to enable/disable Compressed Music Enhancer (p.68).
Settings
Off (Off) Disables Compressed Music Enhancer.
On (On) Enables Compressed Music Enhancer.
Default
TUNER, Bluetooth, USB, (network sources): On (On)
Others: Off (Off)
Y
Compressed Music Enhancer does not work on the following audio sources.
– Signals whose sampling frequency is over 48 kHz
– DSD audio
Hi-Res Mode (HiRes Mode)
Enables/disables the high-resolution mode when "Enhancer" is set to "On". If this function is
set to "On", you can enhance the quality of uncompressed digital audio (such as 2-channel
PCM and FLAC) using Compressed Music Enhancer.
Settings
Enables the high-resolution mode.
On (On)
(The high-resolution mode may not work depending on the audio signal
processing condition.)
Off (Off) Disables the high-resolution mode.
■ Video Processing (Video Process.)
Enables/disables the video signal processing (resolution and aspect ratio) settings configured
in "Processing" (p.128) in the "Setup" menu.
Settings
Direct (Direct) Disables the video signal processing.
Processing
Enables the video signal processing.
(Processing)
■ Input Settings (Input Settings)
Configures the input settings.
X
This setting is applied separately to each input source.
Input Trim (In.Trim)
Corrects volume differences between input sources. If you are bothered by volume differences
when switching between input sources, use this function to correct it.
Setting range
-6.0 dB to 0.0 dB to +6.0 dB (0.5 dB increments)
Audio Select (A.Sel)
Selects the audio input jack to use when more than one audio connection is made for one input
source.
Settings
Automatically selects the audio input jack in the following priority order.
1. HDMI input
Auto (Auto)
2. Digital input (COAXIAL or OPTICAL)
3. Analog input (AUDIO)
Always selects HDMI input. No sounds are produced when no signals are input
HDMI (HDMI)
through the HDMI jack.
Always selects digital input (COAXIAL or OPTICAL). No sounds are produced when
Coax/Opt (Coax/Opt)
no signals are input through the COAXIAL or OPTICAL jack.
Always selects analog input (AUDIO). No sounds are produced when no signals are
Analog (Analog)
input through the AUDIO jacks.
108
En