Password Check - Gigabyte GA-7VAXP-A Ultra User Manual

Select your boot device priority by LAN.
8LAN
8USB-CDROMSelect your boot device priority by USB-CDROM.
Select your boot device priority by USB-ZIP.
8USB-ZIP
Select your boot device priority by USB-FDD.
8USB-FDD
Select your boot device priority by USB-HDD.
8USB-HDD
Select your boot device priority by ZIP.
8ZIP
Disabled this function.
88Disabled
FBoot Up Fl oppy Seek
M During POST, BIOS will determine the floppy disk drive installed is 40 or 80 tracks. 360 K type is
40 tracks 720 K, 1.2 M and 1.44 M are all 80 tracks.
BIOS searches for floppy disk drive to determine it is 40 or 80 tracks. Note
8Enabled
that BIOS can not tell from 720 K, 1.2 M or 1.44 M drive type as they are
all 80tracks.
BIOS will not search for the type of f l oppy disk drive by track number. Note
8Disabled
that there will not be any warning message if the drive installed is 360 K.
(Default value)
F Password Check
The system will boot but will not access to Setup page if the correct
8Setup
password is not entered at the prompt. (Default value)
The system will not boot and will not access to Setup page if the correct
8System
password is not entered at the prompt.
CFlexible AGP 8X
Automatically set AGP transfer rate according to AGP compatibility and
8Auto
stability. (Default value)
Always set AGP transfer rate to 8X if the 8X mode supported by the AGP
88X
card.
Set AGP transfer rate to 4X mode no matter what the AGP transfer rate the
84X
card is.
FInit Display First
M This feature allows you to select the first initation of the monitor display from which card, when
you install an AGP VGA card and a PCI VGA card on board.
Set Init Display First to PCI Slot.
8PCI
Set Init Display First to AGP. (Default value)
8AGP
KT400A Series Motherboard - 42 -