Table of Contents
Advertisement
7.
Loosen the retaining nut.
8.
Remove the filter element.
9.
Clean the oil filter element using the cleaning solvent.
Tube Ref No.
Cleaning solvent
10. Lubricate the oil filter O‑rings.
Tube Ref No.
SAE engine oil 30W
80
11. Reinstall the filter element.
Improper installation of the transmission fluid filter assembly may cause the fluid to foam or leak out, resulting in decreased
efficiency and damage to the transmission. Properly seat the transmission fluid filter during installation.
12. Tighten the retaining nut.
13. Fill the transmission to the proper level with the specified oil. See Filling.
TM 485‑A Technodrive Transmission Fluid
Check Fluid
1.
Remove the dipstick.
IMPORTANT: When checking the fluid level, rest the dipstick on top of the threaded housing hole. Do not screw the
dipstick onto the threaded housing hole.
2.
Check the fluid level as indicated on the dipstick with the dipstick resting on the top of the threaded hole.
NOTE: The fluid level may be somewhat over the maximum mark, as some of the fluid from the transmission fluid cooler
and hoses may have drained back into the transmission.
90-8M0089579
MARCH 2014
eng
Transmission oil filter retaining nut
Description
Description
Where Used
Transmission filter element
Where Used
Transmission filter element O-ring
NOTICE
Section 5 - Maintenance
27978
Obtain Locally
Obtain Locally
Part No.
Part No.
Page 51
Advertisement
Table of Contents
