Lubrication
Greasing the Machine
Service Interval: Every 250 hours—Grease the
machine (lubricate more frequently
in heavy-duty applications).
Grease Type: No. 2 lithium grease
1.
Use a rag to wipe the grease fitting clean so that
foreign matter cannot be forced into the bearing
or bushing.
2.
With a grease gun, apply grease into the grease
fittings on the machine.
3.
Wipe any excess grease off the machine.
The grease fitting locations and quantities are as
follows:
•
Front control arm pivots (2); refer to
Figure 79
Right side shown
1. Front control arm pivot grease fitting
•
Rear control arm pivots (4); refer to
Figure 80
Right side shown
1. Rear control arm pivots grease fittings
•
Ball joints (2); refer to
Figure 79
1. Ball joint grease fitting
g390951
Figure 80
g390953
78
Figure 81
Figure 81
Right side shown
g390950