Table of Contents
Advertisement
• Rotation
The standard orientation of the text is always the reader direc-
tion. Here you can alter the text rotation of in 1° steps.
• Stamp mode
The standard setting for the type of stamp is always "covering".
There are three possible settings:
Covering
-
The stamp overwrites the area of the drawing beneath it.
Transparent
-
In the "Transparent" setting the inserted stamp lies "beneath" the
existing drawing, which means that parts of the stamp can be
overwritten.
Inverting
-
It is only the "Inverting" setting that allows both the drawing as
well as the stamp to be identified in the plot, because the over-
lapping areas are shown inverted.
• Stamp placement
This is where you fix the actual position of the stamp on the
drawing. The frame equates to the drawing, so that you can
choose from the entries for the nine positions from "top", "cen-
tered" to "bottom".
In addition, you can shift this fixed position in the field to the
right of it by a valid size unit. You set the currently valid size units
for RW-470 PLOTBASE in the configuration program and it is
displayed at the bottom of the screen in the status bar.
•
Scale position
With the "Scale position" you determine whether the stamp al-
ways retains its position relative to the edge of the drawing when
the size is changed or whether the distance to the edge of the
drawing should be scaled too.
• Stamp all pages
If you are editing a Multipage document, i.e. a job order con-
tains several drawings, you can fix here whether all the drawings
are to be stamped.
STAMP EDITOR
RW-470 CLIENTS
43
Advertisement
Table of Contents
