Installation; System Requirements - Gestetner 27AO User Manual

Gestetner 27ao: user guide
Hide thumbs Also See for 27AO:
Table of Contents

Advertisement

INSTALLATION

Installation
In this chapter you can read about which system requirements
have to be fulfilled and how to carry out the installation. Fur-
thermore, all the new [sub-] directories and file types that you
will find on your harddrive following the installation are listed in
their own section.

System requirements

Please read through the following recommendations carefully.
They can be very helpful in finding the optimum hardware for
your requirements.
• Operating system
Windows NT 4.0, Windows 95/98/ME or Windows 2000. For
Windows 2000 we recommend Service Pack 1. You can use a
higher Service Pack version, too, but if it does not run, please
change back again to Service Pack 1.
• Network interface/Configuration:
10/100 Base T Ethernet, the TCP/IP configuration is necessary
• Processor & System memory
Dependent on your operating system we recommend following
processors and system memory:
Windows 95/98:
Windows ME:
Windows NT 4.0: Pentium II 200 MHz, at least 64 MB RAM
Windows 2000:
• Harddrive
At least 500 MB.
• Monitor
At least 1024 x 768 pixels resolution.
12
RW-470 CLIENTS
Pentium II 233 MHz, at least 32 MB RAM
Pentium II 233 MHz, at least 64 MB RAM
Pentium II 200 MHz, at least 64 MB RAM

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rw-470 plotclient

Table of Contents