Table of Contents
Advertisement
Available languages
Available languages
OPERATION
After you connected the effect to the mains, the fixture starts running. During the reset, the
motors are trimmed and the device is ready for use afterwards.
Each projector occupies 7 DMX channels. To ensure that the control signals are properly
directed to each projector, the projector requires addressing. This is to be done for every
single projector by display as following described.
Please make sure that you don't have any overlapping channels in order to control each
projector correctly and independently from any other fixture on the DMX data link. If two,
three or more projector is addressed similarly, they will work similarly.
After having addressed all projectors, you may now start operating these via your lighting
controller.
NOTE:
After switching on, the projector will automatically detect whether DMX 512 data is
received or not. If there is no data received at the DMX-input, this situation can occur if:
the 3 PIN XLR plug is not connected with the input of the projector
the controller is switched off or defective
the cable or connector is defective
the signal wires are swap in the input connector
WORKING MODE
Static color mode:
Press MODE button until on the display it will appear "R001" . With UP / DOWN buttons it is
possible to set manually the intensity of Red.
Press MODE button until on the display it will appear "G001" . With UP / DOWN buttons it is
possible to set manually the intensity of Green.
Press MODE button until on the display it will appear "B001" . With UP / DOWN buttons it is
possible to set manually the intensity of Blue.
Strobe mode:
Press MODE buttons until on the display it will appear "ST01" . With UP / DOWN buttons it is
possible to set the strobe speed (from 1 to 30).
Colour change and strobe mode:
Press MODE buttons until on the display it will appear "TL01" . With UP / DOWN buttons it is
possible to set the colour change and strobe speed (from 1 to 30).
Colour change mode:
Press MODE buttons until on the display it will appear "SL01" . With UP / DOWN buttons it is
possible to set the colour change speed (from 1 to 30).
Sound mode:
Press MODE buttons until on the display it will appear "Soud" .
12
Advertisement
Table of Contents
