Operation - PROEL Four Rays Rainbow User Manual

OPERATION

After you connected the effect to the mains, the fixture starts running. During the reset, the
motors are trimmed and the device is ready for use afterwards.
Each projector occupies 5 channels. To ensure that the control signals are properly directed
to each projector, the projector requires addressing. This is to be done for every single
projector by changing the DIP switches as set out in this table.
Dipswitch 1-10:
code 1=1
code 2=2
code 3=4
code 4=8
code 5=16
code 6=32
code 7=64
code 8=128
code 9=256
Please make sure that you don't have any overlapping channels in order to control each
projector correctly and independently from any other fixture on the DMX data link. If two,
three or more projector is addressed similarly, they will work similarly.
After having addressed all projectors, you may now start operating these via your lighting
controller.
NOTE:
After switching on, the projector will automatically detect whether DMX 512 data is
received or not. If there is no data received at the DMX-input, this situation can occur if:
the 3 PIN XLR plug is not connected with the input of the projector
the controller is switched off or defective
the cable or connector is defective
the signal wires are swap in the input connector
WORKING MODE
MODE
1 Sound Mode
2 Auto Mode
3 DMX control
DIPSWITCHES
1 – 10 OFF
1 ON; 2 – 9 OFF
10 ON
13