Operation Instructions - PROEL PLSC575ECN User Manual

• Unscrew the four lamp's protection grids
• Open the lamp lid , and replace the lamp . Be care not to touch the surface of
the new lamp.
• Close the lid.
• Install the light fixture in a place that is well ventilated. Pay attention to checking
if the fan and fan net are smooth.
• The Scoopscan 575ECN uses the 5A / 250V safety fuse. Please use a fuse with
the same specification.

OPERATION INSTRUCTIONS

Scoopscan 575ECN adopts international standard DMX-512 signal, multiple lights can
be controlled by the controller due to use the channel setting (the details are listed in
Appendix 2).
For all installation, having long signal cables or in the presence of electrical noise, for
example a discotheque, it is recommended practice to use a DMX terminator: this assist
in preventing corruption of the digital control signal by external noise. The DMX
terminator is simply an XLR connector with a 120Ω (Ohm) resistor connected across
pins of + and – signals.
The Scoopscan 575ECN uses core XLR outlet (plug). A transfer line from 5 core to 3
core will be needed if the controller you use is 5 core outlet (plug). (Please refer to
Appendix 1).
The lamp reaches its full power after 5 - 10 minutes since you powered on the unit. For
this reason, once you switched off the lamp, you must wait at least 10 minutes before
switching on the lamp one more time.
When power is on, the equipment will undertake self-examination, and can undertake
operation after the self-examination is finished.
Please don't shake the equipment when it is in operation.
10