Service Required Errors - Frymaster FootPrint OCF30G Service & Parts Manual

1.14.2 3000 Controller Useful Codes
To enter any of the following codes: Press and hold the  button until Main Menu changing to
Product setup is displayed. Press  to scroll to Tech Mode and press TECH MODE
ENTER CODE is displayed. Press the  button. Enter a code number below:

Change Fryer Type, CE/Non-CE, Fresh Oil Setup, Waste Oil Setup and Energy Type –
Enter 7628.

Clear E-Log, Clear Passwords, Change Lane Count, Adjust Max Cook Temp and
Perform High Limit Test, – Enter 3000.

Reset Factory Menu - Enter 3322. The controller display flashes and quickly counts from 1-40
and switches to off. (NOTE: This will delete any hand-entered menu items).

Reset BADCRC Message - Disconnect board locator plug (J3). Reinsert plug. Enter 9988.
Controller display switches to off. Remove and then restore power to the controller using the 20-
pin plug.

Change from F° to C° - Enter 1658. The controller displays off. Turn the controller on and
check temperature to see the temperature scale. If the desired scale is not displayed, repeat.

Reset RECOVERY FAULT CALL SERVICE – Enter 0042.
PASSWORDS
Product Setup Mode: Press and hold the  button until Main Menu changing to Product
setup is displayed. Press the  button. ENTER CODE is displayed. Enter 1650.
Vat Setup Mode: Press and hold the  button. Main Menu changing to Product setup is
displayed. Press  to scroll to Vat Setup and press . ENTER CODE is displayed. Enter 1656.
Tech Mode: Press and hold the  button until Main Menu changing to Product setup is
displayed. Press  to scroll to Tech Mode and press .
button. ENTER CODE is displayed. Enter 3000 or a code from above.

1.14.3 Service Required Errors

A SERVICE REQUIRED error alternating with YES displays on the controller. After YES is
pressed the alarm is silenced. The controller displays an error message from the list below
three times with the location of the error. Then the controller displays SYSTEM ERROR
FIXED? YES/NO. Press YES if fixed. If NO is chosen the system returns to cook mode for 15
minutes then redisplays error until issue is fixed.
TECH MODE is displayed. Press the 
1-35