Audio Technica ATW-2120 Installation And Operation Manual page 10

WIRELESS ESSENTIALS ™ MICROPHONES AND CABLES
AT829cW Miniature cardioid condenser lavalier microphone.
Includes clothing clip and windscreen.
MT830cW Miniature omnidirectional condenser lavalier
microphone. Includes clothing clip and windscreen.
MT830cW-TH "Theater" model, same as MT830cW except beige color
mic and cable for concealment.
AT831cW Miniature cardioid condenser lavalier microphone.
Includes clothing clip and windscreen.
AT889cW Headworn noise-canceling condenser microphone.
Includes windscreen and cable clip.
AT898cW Subminiature cardioid condenser lavalier microphone.
Includes clothing clip base, viper clip base, magnet clip
base,three single mic holders, two double mic holders and
two windscreens.
AT899cW Subminiature omnidirectional condenser lavalier microphone.
Includes AT899AK accessory kit.
AT899cW-TH "Theater" model, same as AT899cW except beige color mic
and cable concealment. Includes AT899AK-TH accessory kit.
ATM35cW Cardioid condenser instrument microphone.
Includes AT8418 clip-on instrument mount.
ATM73cW Headworn cardioid condenser microphone.
Includes windscreen.
ATM75cW Headworn cardioid condenser microphone.
Includes windscreen.
PRO 8HEcW Headworn hypercardioid dynamic microphone.
Includes windscreen and cable clip.
PRO 35xcW Cardioid condenser instrument microphone.
Includes AT8418 clip-on instrument mount.
AT-GCW Hi-Z instrument/guitar cable with
XLRW Connecting cable for UniPak transmitter with an XLRF-type
input connector, for Lo-Z microphones with XLRM-type
output terminations.
10
Optional System Accessories
1 / " phone plug.
4
RECEIVER ACCESSORIES
AEW-DA660D UHF (655-680 MHz) active unity-gain antenna distribution
system provides two "1-in, 4-out" RF channels; connects a
pair of antennas to as many as four diversity receivers;
cascade output provided as a directional coupler. AC
pass-through allows daisy-chain AC hookup. Defeatable
antenna power. Metal receiver chassis with reinforced
mounting ears and rear rack mount capability. Includes
detachable IEC power cable, IEC pass-through cable, ten RF
cables, front-mount antenna cables and connectors, four DC
power cables to power up to four 2000 Series receivers.
Mounts in a single 19" rack space.
AT8630 Joining-plate kit allows rack-mounting two ATW-R2100
receivers side-by-side in a single (1U) 19" rack space.
ATW-A20 Pair of UHF ground-plane antennas with
mounting to microphone stands, etc. For use with
ATW-R2100 receivers. Takes RF cables with BNC
connectors, not included; see RF Cables below.
ATW-A49 Pair of UHF wide-band directional LPDA (log periodic dipole
array) antennas provide enhanced signal pickup for UHF
wireless systems throughout a wide band range
(440-900 MHz). Each antenna paddle is matched to 50 ohms
impedance with intergral high-quality low-loss BNC connector;
6 dB gain. For permanent or temporary installation; mounts
to 5 / "-27 threads.
8
ATW-RA1 Rack-mount antenna kit brings antenna inputs to the front of
receiver for ease of setup, or when receiver is enclosed in a
metal rack. Includes a pair of extendible antennas. NOTE:
Two adapter kits are required when mounting two receivers
side-by-side in a single 19" rack space.
RF Cables Low-loss design, 50 ohm impedance, with BNC-to-BNC
connectors:
AC12
AC25
AC50
AC100
TRANSMITTER ACCESSORIES
AT8114 Foam windscreen for handheld transmitter.
AT8141 Water-resistant pouch for UniPak transmitter.
AT8456a Quiet-Flex™ stand clamp for handheld transmitter,
threads.
5 / "-27 thread for
8
RG58-type cable (12')
RG8-type cable (25')
RG8-type cable (50')
RG8-type cable (100')
5 /
8
"-27