Kyocera ECOSYS P4140dn Operation Manual page 56

Installing and Setting up the Machine > Network Setup
7
Configuring the Connection by Using Push Button
When your computer or handheld device does not support Wi-Fi Direct but supports WPS, you can configure the
network using push button.
1
2
3
4
5
IMPORTANT
You can connect up to three handheld devices at the same time using Wi-Fi Direct setting. When the devices
that support Wi-Fi Direct are connected, if you want to connect other device, disconnect the already-
connected devices from the network. The disconnection methods are as follows:
• Disconnect the network from the computer or handheld computer
• Disconnecting all devices from the network on the operation panel
Select [Wi-Fi Direct] key > [▲] [▼] key > [ConnectionStatus] > [OK] key > [Menu] > [▲] [▼] key >
[Disconnect All] > [OK] key
• Configuring auto disconnecting time from the System menu
Wi-Fi Settings (page 8-13)
• Configuring auto disconnecting time from the Command Center RX
Command Center RX User Guide
Configure the handheld device.
1
[Settings] > [Wi-Fi]
2
Select the network name (SSID) appeared in step 6 from the list.
3
Enter the password that was provided in step 6 > [Connect]
The network between this machine and the handheld device is configured.
Display the screen.
[Menu] key > [▲] [] key > [Network] > [OK] key > [▲] [] key > [Wi-Fi Direct Set] > 
[OK] key > [▲] [] key > [Wi-Fi Direct] > [OK] key
Configure the settings.
[▲] [] key > [On] > [OK] key
Restart the network.
[Menu] key > [▲] [] key > [Network] > [OK] key > [▲] [] key > [Restart Network] > 
[OK] key > [Yes]
[Status] key > [▲] [▼] key > [Wi-Fi Direct] > [OK] key >
[PushButton Setup] > [OK] key
Press the push button on the computer or handheld device and
select [Push Button] on the screen of operation panel
simultaneously > [Next].
The network between this machine and the computer or handheld device is configured.
2-25