Programming The Remote Control - Gateway 23-inch User Manual

Programming the remote control

The TV component button has been preset to work with your Gateway LCD TV
(program code 0080). You can program the remote control to work with as may
as seven other components.
To program the remote to control other components:
1
Turn on the component.
2
Press the matching component button on the remote control.
3
Press and hold the
4
Enter the programming code for the component and manufacturer. For a
list of component programming codes, see "Component program codes"
on page 8. If the code is accepted, the LED flashes twice after the last digit
is entered.
If the LED does not flash twice, repeat Steps 2 through 4 with the next
code listed for the component and manufacturer.
Important
5
Point the remote control at the component and press the
The component should turn off.
Tips & Tricks
button until the LED flashes twice.
SETUP
Make sure that you try all the codes listed until you find
the one that works for the component.
If you cannot find your manufacturer in the component list
or the program code does not work, you can use the
remote control to search for the correct component code.
See "Searching for component codes" on page 19.
www.gateway.com
Programming the remote control
button.
POWER
7