Gateway px pÁ6y wÁTpÁ@tip Inserting the batteries ■ Identifying the remote control buttons ■ Programming the remote control ■ Using the remote control ■ Troubleshooting typical problems ■...
Inserting batteries To install batteries: ■ Insert two AA batteries into the remote control. Make sure that you match the on the batteries with the symbols inside the battery compartment. – www.gateway.com –...
Programs the remote control to recognize a component. For programming instructions, see “Programming the remote control” on page 7. TV. Selects a programmed TV. Pre-programmed for your 30-inch LCD TV. DVD. Selects a programmed DVD player. Pre-programmed for Gateway’s DVD player. VCR. Selects a programmed VCR.
Page 8
LAST. Recalls the previously viewed channel. SLEEP. Turns on the sleep timer. INPUT. Changes the input source. Forward/ Reverse. Changes the channel. Forwards or rewinds the CD, DVD, or VCR when the component is turned on and selected with the remote control. www.gateway.com...
Page 9
GUIDE does not work in TV mode. INFO. Shows the current status of your LCD TV, such as the video input source, audio status, and channel number. . Navigate the on-screen display (OSD) menus.
Page 10
PIP AUDIO. Toggles the audio from the program in the main picture to the program in the PIP sub-picture. PIP TV. Opens the PIP sub-picture to the same location and size, as it was the last time it was open, and sets the source to TV.
Programming the remote control The TV component button has been preset to work with your Gateway LCD TV (program code 0080). You can program the remote control to work with as many as seven other components. To program the remote to control other components: Turn on the component using the component’s power button.
Page 12
This is the third number in the component code. Press and count the number of blinks. This is the last number in the component code. button until the LED flashes twice. SETUP button until the LED flashes twice. SETUP www.gateway.com POWER...
You can reassign the component buttons on the remote control if you have more than one of the same type of component. Example: If you are using the remote to control a DVD, TV, and two VCRs, you can reassign the CD button as a second VCR button. To reassign component buttons:...
To clear the volume lock to the TV (set the volume controls back to the components): Press and hold the Press the component button on the remote control. Press . The LED flashes twice. 9 9 3 Press to clear all volume locks.
Your LCD TV features an on-screen display (OSD) that lets you adjust and save contrast, brightness, and other settings. The TV saves changes you make to the settings, even if you turn off the TV. See the documentation that came with your LCD TV for more information about the OSD.
“Programming the remote control” on page ■ Make sure that you tried all the program codes listed for the component manufacturer. “Component codes” on page ■ Perform the component code search procedure. See on page “Inserting batteries” on page “Searching for component codes” www.gateway.com “Programming...
Appendix A Component program codes Amplifiers and tuners ■ Cable set-top boxes ■ CD players ■ DVD players ■ Computer and Home automation ■ Satellite set-top boxes ■ Receivers ■ ■ VCRs ■...
Page 29
In the interest of continued product development, Gateway reserves the right to make improvements in this manual and the products it describes at any time, without notices or obligation.