Table of Contents
Advertisement
DIRECT-VENT FIREPLACE (NATURAL/PROPANE/LP)
FIREPLACE
INSTALLATION
Continued
Fireplace Models DDV37N/P and
DDV41N/P
1.
Place log #1 (back log) on grate. Make
sure the lower middle section of the log
fits securely into the open area in back
of grate (see Figure 51).
2.
Place log #2 (two log assembly) onto pins
on left front and middle section of the front
burner (see Figure 52).
3. Place log #3 (crossover assembly) onto
the front right pin on front burner with
the crossover log resting in notch on
back log (see Figure 53).
4. Place lava rock along sides and front of
firebox bottom.
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner could cause
performance problems.
It is not necessary to use all of the lava
rock provided.
5.
Pull ember material apart into pieces no
larger than a dime. Place these pieces
loosely onto the exposed section of the
front burner and space between logs 2
and 3 where front burner is exposed (see
Figure 54). This will create the glowing
appearance as the flame touches the em-
ber material. Do not block ports by us-
ing too much ember material in one area.
It is not necessary to use all of the em-
ber material provided.
6.
Replace the glass door and screen. See
Removing/Replacing Screen and Glass
Door, page 21.
WARNING: The glass door
and screen must be securely in
place before running this fireplace.
Do not run this fireplace if glass or
screen is missing or broken.
BDV37(41)N/P AND DDV37(41)N/P
®
Figure 51 - Installing Log No. 1
Figure 52 - Installing Log Assembly No. 2
24
Figure 53- Installing Log Assembly No. 3
Ember Material
Figure 54 - Placing Ember Material on
Burner
104493
Advertisement
Table of Contents
