Vanguard BDV37N Owner's Operation And Installation Manual page 22

DIRECT-VENT FIREPLACE (NATURAL/PROPANE/LP)
FIREPLACE
INSTALLATION
Continued
INSTALLING OPTIONAL
BRICK LINER D8037/D8041
WARNING: If fireplace has
been running, turn off and un-
plug fireplace. Let cool before
installing brick liner.
This brick liner kit is optional. You may
purchase brick liner from your local dealer
or see Accessories, page 33.
CAUTION: Always handle
brick panels with two hands. Do
not force brick panels into place.
Excessive force will break brick
panels.
1. Remove screen and glass door. See Re-
moving/Replacing Screen and Glass
Door, page 21.
2. If installing brick liner in new fireplace,
go to step 3. If installing brick liner in
an existing fireplace, carefully remove
logs, lava rock, and ember material.
3. Install rear brick panel first. Rest bot-
tom edge of panel on back edge of grate
(see Figure 44).
4. Loosely secure retainer brackets to
grate. Brackets are adjustable left to
right to allow proper placement of
panel. These will hold rear panel in
place while installing side panels.
5. Install left side brick panel by sliding
it between the grate and the side of the
firebox (see Figure 45).
6. Slide the left retainer bracket against
the left side brick panel. Tighten the
bracket screw. This secures both the left
side and rear brick panels.
7. Install the right brick panel using the
same method described in step 3.
BDV37(41)N/P AND DDV37(41)N/P
®
8. Slide the right retainer bracket against
the right side brick panel. Tighten the
bracket screw. This secures both the
right side and rear brick panels.
9. Follow instructions on page 23 to install
logs, lava rock, and ember material.
10. Replace glass door and screen (see
page 21).
Rear Brick Panel
Retaining Brackets
Figure 44 - Installing Rear Brick Panel and Retainer Brackets
Left Side
Brick Panel
Figure 45 - Installing Left Side Brick Panel
22
Retainer
Brackets
104493