Table of Contents
Advertisement
FIREPLACE
INSTALLATION
Continued
REMOVING/REPLACING
SCREEN AND GLASS DOOR
You must remove screen and glass door to
install optional brick liners, logs, lava rock,
and ember material.
CAUTION: Do not operate this
fireplace with a broken glass door
panel or screen. Do not operate
this fireplace without the glass
door panel and screen securely
in place. For replacement part
information see Replacement
Parts , page 31.
1. Remove the upper louver panel by lift-
ing upward and out (see Figure 41).
2. Slide screen upward out of lower brack-
ets. Rotate screen toward you so that
screen clips rotate out away from fire-
box. Slide screen out of clips. See Fig-
ure 42.
3. Remove the screws from the three tabs
at the top of the glass door while hold-
ing door securely keeping it from fall-
ing forward.
4. Grasp door by both sides and ease it
upward off of the lower bracket (see
Figure 43).
5. To replace glass door and screen, fol-
low the above instructions in reverse.
Top Louver
Panel
Figure 41 - Removing Top Louver Panel
104493
Screen
Clip
Screen
Figure 42 - Removing/Replacing Screen
Screw
Glass Door
Assembly
Lower Bracket for
Glass Door Assembly
Figure 43 - Removing/Replacing Glass Door
Attaching Magnetic Decorative
Brass Strips - DDV Only
The DDV fireplaces come with a set of two
magnetic decorative brass strips. Before at-
taching strips to fireplace, remove plastic
film from brass pieces. After installing both
the door and the screen, attach these strips to
the glass door frame just above and below
the screen.
21
OWNER'S MANUAL
Lower Bracket
for Screen
Continued
Advertisement
Table of Contents
