Fujitsu FI-5220C Operator's Manual page 80

3.9 Detecting Multi feeds(6)
fi-5120C / fi-5220C Image Scanner Operator Guide
3.9 Detecting Multi feeds (6)
3. Specify the settings on the "Area for Multi feed Detection..." screen.
1) Mark the "Enable" check box.
HINT
2) Select if the Multi Feed Detection shall be applied or not for a set area.
To specify an area for which the Multi Feed Detection will be conducted:
●
check "Select area for applying Multi feed Detection."
To specify an area for which the Multi Feed Detection will NOT be conducted:
●
check "Select area for not applying Multi feed Detection."
3) Specify the "Start" of the area.
Enter the position from where the detection shall be started, meassured from the document's top edge.
(Possible values: 0 through 510mm; value of the even number)
4) Specify the "End" of the area.
Enter the position where the detection shall end, meassured from the document's top edge.
(Possible values: 0 through 510mm; value of the even number)
ATTENTION
The value for "End" must be larger than the value for "Start."
file://///Hd-htgle21/Manual/fi-5120C_5220C-lynx2/OG/R03/contents/EN/03/c03_09_06.htm2006/08/29 16:00:52
1
You can select an area meassured from the top of the document, for which
●
the multi feed detection will be conducted (or not).
If you do not mark the "Enabled" checkbox, multi feed detection will monitor
●
the paper overlap over the central column (width: 35mm) of the document
to be scanned (For details, see the illustration
monitoring area" on section 7.5.). In this case, the settings for "Select Area
to enable Multi feed Detection" / " Select Area to disable Multi feed
Detection" will not be available.
1
All Rights Reserved Copyright 2006 © PFULIMITED
2 3 4 5
6
2 3 4 5
6
TROUBLE SHOOTING
CONTENTS MAP
TOP
"Multi feed detection