Oki MC573dn User Manual page 213

This PDF file is password protected.
This PDF file is password protected.
Valid password required to print document.
This PDF needs authentication.
No communication with the SNTP server.
Obtaining current time from the SNTP server failed. Check the server.
USB Memory disconnected.
The USB Memory was removed while printing from USB Memory. Do not remove USB Memory while printing is in
progress.
Cannot open the file.
The specified file could not be Opened. Check the file.
Cannot read the file.
Files could not be read. Check the device where the files are stored.
Image Drum Sensor Error.
The sensor error has occurred in the image drum indicated on the screen.
Uninstall the image drum, and then install it again.
If the message persists, uninstall the toner cartridge and install it again.
Rear Output Tray is open, so 2-sided printing is disabled. Error code: 581
2-sided printing (duplex printing) failed because the rear output tray is open.
Close the rear output tray and tray again.
Printing was stopped. Rear Output Tray was opened during printing. Open the Output
Tray. Error code: 409
The rear output tray was moved while printing.
Open the output tray and remove the jammed paper remaining inside of the unit.
Wait Timeout in menu is disabled. Printing is disabled except by USB. Clear page
buffer and enable time out in menu.
Wait Timeout is disabled.
Press [Device Settings], select [Admin Setup] > [Print Setup] > [Print menu] > [Printer Adjust] > [Timeout Injob] on
the touch panel, and then select a longer print timeout value.
Insufficient memory occurred during Fax Tx reservation.
Insufficient memory error has occurred during Scan To fax.
Perform the following to increase the available memory.
• Check the reserved transmission.
• Print the documents received with the confidential reception.
• Delete the documents stored in the bulletin board box and images received using Secure Receive.
Insufficient memory.
Insufficient memory error has occurred during fax reception.
Perform the following to increase the available memory.
• Check the reserved transmission.
• Check whether paper jams or paper runs out.
• Print the documents received with the confidential reception.
• Delete the documents stored in the bulletin board box and images received using Secure Receive.
E-mail receiving has been cancelled.
Receiving E-mail was cancelled because the format of the E-mail is not supported or attached file is too large.
Check the file format and size of the attached file.
Wireless settings are incomplete.
Wrong values are set or items remain unset in the wireless LAN settings. Check the wireless settings.
Not connected to wireless access point.
No wireless LAN access points are found.
Make sure that the access point is turned on.
Disconnect and re-connect to wireless LAN.
Wireless startup failed.
Turn off the machine, check that the wireless LAN module is correctly installed, and then reboot the machine. If the
error persists, contact your dealer.
- 213 -
9. Troubleshooting