4. Level Calibration
Adjust the volume level of each speaker.
Setting Item
Default Value
Front Left
0 dB
Center
0 dB
Front Right
0 dB
Height Left
0 dB
Height Right
0 dB
Surround Right
0 dB
Surround Left
0 dB
Subwoofer
0 dB
Setting Details
Select a value between "-12 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Select a value between "-12 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Select a value between "-12 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Select a value between "-12 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Select a value between "-12 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Select a value between "-12 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Select a value between "-12 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Select a value between "-15 dB" and "+12 dB"
(in 1 dB increments). A test tone will be output each
time you change the value. Select the desired level.
Contents
Connections
≫
5. Dolby Enabled Speaker
Change the settings of Dolby Enabled Speakers.
Setting Item
Default Value
Dolby Enabled
1.80 m
Speaker to Ceiling
AccuReflex
Off
• This setting can be selected when "Configuration" - "Height Speaker" is set to "Dolby
Speaker".
6. Speaker Virtualizer
The Speaker Virtualizer function can be switched between On and Off.
Setting Item
Default Value
Speaker
On
Virtualizer
76
Front Panel≫ Rear Panel≫ Remote≫
Playback
Setup
≫
≫
Setting Details
Set the distance between the Dolby Enabled
Speaker and the ceiling. Select between
"0.1 ft/0.03 m" and "15.0 ft/4.50 m" (0.1 ft/0.03 m
units).
• The unit of distance (ft/m) is displayed using the
unit selected for the "Distance" setting.
You can enhance the reflection effect of Dolby
Enabled Speakers from the ceiling.
"Off": When this function is not used
"On": When this function is used
Setting Details
"On": Listening modes such as T-D that have virtual
speaker effects can be selected.
"Off": Listening modes such as T-D that have virtual
speaker effects cannot be selected.
≫