Table of Contents
Advertisement
Software Description
2
Software Description
2.1
Setup
The one-time procedure for installing the GUI software is as follows:
1. Download and install the TI SigCon Architect GUI. The steps for installing the software are as follows:
1. Go to
www.ti.com/tool/sigconarchitect
time this document was written, the latest version of SigCon Architect is 2.0.0.4.
2. Extract the executable file (.EXE) from the downloaded file and run the executable.
3. Follow the installation wizard's instructions to install SigCon Architect.
4. Download the DS250DF810 profile file from the TI SigCon Architect page.
5. Extract the executable file (.EXE) from the downloaded file and run the executable.
4
DS250DF810EVM User's Guide
Figure 2. Download SigCon Architect from www.ti.com
Copyright © 2015–2019, Texas Instruments Incorporated
and download the latest version of SigCon Architect. At the
SNLU180C – August 2015 – Revised September 2019
www.ti.com
Submit Documentation Feedback
Advertisement
Table of Contents
