Complete Installation - Jenn-Air JGC3530GS Installation Instructions Manual

Complete Connection
1. Open the manual shut-off valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A
A. Closed valve
B. Open valve
2. Test all connections by brushing on an approved
noncorrosive leak-detection solution. If bubbles
appear, a leak is indicated. Correct any leak found.
3. Install all burner caps and burner bases.
A
B
C
Single Burner
A. Cap
B. Spreader
C. Electrode
Burner installation:
To install the spreader (B), insert the electrode (C) into the
spreader hole.
Install surface grates:
The surface grates are positioned correctly when the thick ribs
form a frame around the outer edge and the thin ribs are located
across the middle. All burners will be centered with the burner
openings in the grates. See the following illustration.
NOTE: The end grates are different than the center grate.
Do not use the end grate in the center grate position.
B
A
C A
A. Thick ribs
B. Thin ribs
C. End grates
D. Center grate
B
A
B
C
Double Burner
A. Cap
B. Spreader
C. Electrode
A B
D C
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
4. Plug into a grounded 3 prong outlet.

Complete Installation

Electronic Ignition System
Check Operation of Surface Burners
1. Push in and turn the surface burner control knobs to IGNITE.
The surface burner flame should light within 4 seconds.
The first time a surface burner is lit, it may take longer than
4 seconds to light because of air in the gas line.
2. Turn the control knob to HI and check for a blue-colored
flame. It should be clean and soft in character. No yellow tip,
blowing, or lifting of flame should occur. Occasional orange
flashes are normal and reflect different elements in the air
or gas.
3. Repeat for Lo.
4. Repeat for Simmer.
5. After verifying the proper burner operation, turn the control
knobs to OFF.
If burners do not light properly:
Turn the surface burner control knob to OFF.
■
Check that the power supply cord is plugged in and the
■
circuit breaker has not tripped or the fuse blown.
Check that the gas shut-off valve is set to the open position.
■
Check that the burner bases and caps are properly
■
positioned on the burners.
A
Recheck the operation of the surface burners. If a burner does
not light at this point, call 1-800-JENN-AIR (1-800-536-6247).
WARNING
A. Correct
B. Incorrect
9