Kyocera 1102R73AS0 Operation Manual page 355

Troubleshooting > Troubleshooting
Symptom
The altitude is 1000 m or
higher and irregular
horizontal white lines appear
in the image.
The altitude is 1000 m or
higher and dots appear in
the image.
Printouts have vertical lines.
Dirt on the top edge or back
of the paper.
Part of the image is
periodically faint or shows
white lines.
Checkpoints
―
―
Is the slit glass dirty?
―
Is the interior of the machine dirty?
―
―
―
Corrective Actions
Select the [System Menu/Counter] key
> [Adjustment/Maintenance] >
[Service Setting] > [Altitude
Adjustment], and set to an elevation
one level higher than the current setting.
Select the [System Menu/Counter] key
> [Adjustment/Maintenance] >
[Service Setting] > [Altitude
Adjustment], and set to an elevation
one level higher than the current setting.
Clean the slit glass.
Run [Laser Scanner Cleaning].
Clean the interior of the machine.
Open and then close the rear cover.
Run [Drum Refresh].
Select the [System Menu/Counter] key
> [Adjustment/Maintenance] >
[Service Setting] > [MC] and decrease
the adjustment value. Decrease the
adjustment value 1 level at a time from
the current value. If there is no
improvement after the value is
decreased by 1 level, decrease by 1
level again. If there is still no
improvement, return the setting to the
original value.
10-14
Reference
Page
―
―
page 10-3
page 10-34
page 10-4
―
page 10-34
―