Connecting A Wireless Full Hd Kit (Wdp02) - BenQ W2000w User Manual

Connecting a wireless Full HD Kit (WDP02)

The next generation of Wireless Full HD kit is available from the place you purchased the projector.
The projector is designed to accommodate a receiver by which the projector receives a signal from a
transmitter and displays transmitted images. Refer to the illustrations below for a quick connection of the
wireless transmission device.
1. Turn the power off and disconnect the
projector from the power outlet. If the lamp
is hot, avoid burns by waiting for
approximately 45 minutes until the lamp has
cooled.
2. Loosen the screws that secure the lamp
cover on the top of the projector until the
lamp cover loosens.
3. Remove the lamp cover from the projector.
4. Place the receiver into the compartment, and
press it backwards and then downwards until
it clicks into place.
5. Plug the HDMI cable and USB Mini-B cable to
the receiver.
Do not strain the HDMI cable and USB cable
as this could cause malfunction to the cables.
18 Connection
2 2
1
6. Connect appropriate AV equipment to the
transmitter.
3
7. Power on the projector and switch to the
Wireless input source.
8. For more operation details, refer to the user
manual of the Wireless Full HD Kit (WDP02).
1
2