Table of Contents
Advertisement
• Full Display to adjust the image to the projector's screen size as you scale the image
7. If you selected Auto as the Scale setting, you can skip the remaining steps. If you selected Manual,
adjust each of the following options as necessary:
• Select – or + to scale the image horizontally and vertically at the same time
Note: You can set a value between 0.5 and 10.
• Select Scale Vertically to scale the image vertically only
• Select Scale Horizontally to scale the image horizontally only
8. Select the Clip Adjustment setting and use the arrow buttons to adjust the coordinates and size of
each image as you view the screen.
9. Select the Clip Range setting to preview the area you just selected.
10. Press the Menu button to exit.
Parent topic:
Related tasks
Blending the Image Edges
Related topics
Tiling Images into One Image
Enabling Protocol Emulation
You can use protocol emulation to control your projector with the same RS-232 control codes as those
used by the manufacturers of other projectors. This lets you control a group of projectors from a common
controller.
1. Make sure the projector is turned on.
2. Connect a controller to the RS-232C port on the projector.
3. Do one of the following:
• Press and hold the Test Pattern button on the remote control for at least five seconds.
• Select the Extended menu, highlight the Standby Mode setting, and hold down the right arrow
button on the remote control or projector control panel for at least five seconds.
You see the Protocol Emulation screen.
Using Multiple Projectors
189
Advertisement
Table of Contents
