Table of Contents
Advertisement
Parent topic:
Setting the Remote Control ID
The remote control's ID is set to 0 by default so it can operate any compatible projector. If you want to set
the remote control to operate only a particular projector, you need to set the remote control's ID to match
the projector's ID.
1. Turn on the projector you want the remote control to operate with exclusively.
2. Set the remote control ID switch to On.
3. Hold down the ID button on the remote control while you press the numeric button that matches the
projector's ID. (Enter a two-digit number, such as 01 for projector ID 1.) Then release the buttons.
Note: To temporarily display the projector's ID on the screen, press the i button and press the ID
button. If the batteries are left out of the remote control for an extended period, the remote control ID
returns to its default setting.
Parent topic:
Projector Identification System for Multiple Projector Control
Projector Identification System for Multiple Projector Control
172
Advertisement
Table of Contents
