Using The Remote Controller - Mitsubishi Electric CRHV-P600YA-HPB Service Handbook

[ IV Remote Controller ]
IV Remote Controller

[1] Using the Remote Controller

<1> Starting and Stopping Operation and
Changing the Operation Mode
2
3
Set Tempera-
3
ture buttons
Mode (BACK) 2
BACK
button
PAR-W21MAA
To Start Operation
1. Press the ON/OFF (BACK) button
The power indicator 1 and the display will light up.
HWE1312A
4
˚C
˚C
1 Power
TEMP. ON/OFF
MENU ON/OFF INITIAL SETTING CIR.WATER
MONITOR/SET DAY CHECK TEST
1
CLOCK CLEAR
1 .
To Stop Operation
1. Press the ON/OFF (BACK) button
The power indicator
The remote controller will remember the last mode and temperature
settings when turned off.
To select the Mode
1. With the power turned on, press the Mode (BACK) button
desired mode appears.
• Each press changes the operation mode in the following sequence
Indicator
(see notes *1 and *2 below):
Heating→Heating ECO→Hot water→Anti-freeze→Back to Heating.
ON/OFF
The currently selected mode will appear in the area labeled
(BACK)
button
*1 If CN142A 3-4 is ON (CLOSE), the operation mode cannot be changed
from the remote controller.
*2 The available modes vary depending on the model.
*3 Refer to section [2] "Function Settings" [4]-2. (2) for how to change the
settings for a specific function.
- 47 -
1 while the unit is in operation.
1 and the display will light off.
2
until the
2 .
GB