Hawking HW17ACM User Manual page 52

VLAN ID
Auto Channel
Auto Channel Range
Auto Channel Interval
Channel Bandwidth
BSS BasicRate Set
When auto channel is disabled, select a wireless channel manually:
Channel
Channel Bandwidth
BSS BasicRate Set
4-3-2-2. Advanced
values on this page unless you are already familiar with these functions.
Changing these settings can adversely affect the performance of your access point.
47
Specify a VLAN ID for each SSID.
Enable/disable auto channel selection. Auto channel
selection will automatically set the wireless channel for the
access point's 5GHz frequency based on availability and
potential interference. When disabled, select a channel
manually as shown in the next table.
Select a range from which the auto channel setting (above)
will choose a channel.
Specify a frequency for how often the auto channel setting
will check/reassign the wireless channel. Check/uncheck the
"Change channel even if clients are connected" box according
to your preference.
Set the channel bandwidth: 20MHz (lower performance but
less interference), Auto 40/20MHz or Auto 80/40/20MHz
(automatically select based on interference level).
Set a Basic Service Set (BSS) rate: this is a series of rates to
control communication frames for wireless clients.
Select a wireless channel.
Set the channel bandwidth: 20MHz (lower performance but
less interference), Auto 40/20MHz or Auto 80/40/20MHz
(automatically select based on interference level).
Set a Basic Service Set (BSS) rate: this is a series of rates to
control communication frames for wireless clients.
These settings are for experienced users only. Please do not change any of the