Datavideo SE-200 Pro Instruction Manual page 45

6.5.3 AUTO RECORD option:
sequence automatically.
a) Make sure a blank tape is inserted and rewound in your recording VCR. If the
Record Sub-Mode menu is not on screen, press the "SUB MODE" key to return
to Record Sub-Mode:
b) Press the "2" key to bring up the Auto Record screen (similar to the Preview
screen):
c) Press the "EDIT" key. As in the Preview, an on--screen prompt will ask if source
tape is correct.
d) If the source tape is correct (ready to play back), press the "EDIT" key. When
you press the "EDIT" key, the source tape will play back automatically (and
the recording VCR will record) the sequence of scenes you have edited.
Note: The steps on "Calibration," "Append Tape" and "synchronous sources"
described in the Preview process, (sect. 6.5.2) also apply to the Auto
Record process.
e) At the end of the Auto Record process, the screen will say "AUTO EDIT END".
Rewind the tape in the recording VCR and play it back to view the results of
your edit.
select this to record all of the scenes in your edited
RECORD MODE
1. PREVIEW
2. AUTO RECORD
3. MANUAL EDIT
SOURCE A 1 +0:00:00:00
NEXT SN:01
PLEASE INSERT
TAPE-1 TO SOURCE-A
AND RESET COUNTER THEN
PRESS "EDIT" TO START
NEXT IN: A25 SP1
NEXT OUT: A01 SP1
SOURCE A 1 +0:00:00:00
NEXT SN:01 AUTO
NEXT IN: A25 SP1
NEXT OUT: A01 SP1
41
OUT
OUT