Datavideo SE-200 Pro Instruction Manual page 39

SQ : 001 SR : B2
IN +031001 CUT
0UT +052002 CUT
SQ EFFECT PAGE
01. TITLER T01
02.
03.
ii. With the cursor on line 01 in the "EFFECT" column, press the "GPI" key. The
word "GPI-001" will appear in the "EFFECT" column.
Note: The "IN" and "OUT" counter numbers of the scene will also appear on
screen in the "COUNTER" column. You can now select the precise point
within the scene where you want the effect to appear.
iii. Move cursor to the "COUNTER" column. To adjust the counter numbers,
press the "IN" key (to increase by "seconds"), the "FWD" key (to increase by
"frames"), the "OUT" key (to decrease by "seconds"), or the "REV" key (to
decrease by "frames").
Note: If the external device utilizes a SINGLE GPI trigger, you need to adjust
the "IN" counter number only. If the external device utilizes a DOUBLE GPI
trigger, you need to adjust both the "IN" and "OUT" counter numbers (to
establish both the start and end of the effect's duration on screen).
Note: Both of the effect's "IN" and "OUT" counter numbers must be higher
than the scene's "IN" counter number, but lower than the scene's "OUT"
counter number. The warning "DURATION ERROR" will be pop up on TV
screen if counter number of GPI or TITLER trigger point is higher than "OUT"
point of scene.
NOTE: You can add up to 100 GPI--triggered effects--or combination of
title effects and GPI--triggered effects-to each scene.
6.4.5 Creating a Project with synchronous video sources.
The techniques for setting up a Project (rearranging scenes, adding effects, etc.)
are basically the same for synchronous sources as for non-synchronous sources
(see section 2, above). With two synchronous sources, however, you can insert
scenes from the second source into your edited sequence and also create A/B
Roll effects.
NOTE: it is important here to review the source indicator in the "SR" column on
the Project Sub-Mode screen:
SN : 01
SP 1
Press the "GPI" key
SP 1
COUNTER
+0033020
SQ SR SN CAL. DURATION
001: A.1 01
IN +0010612
OUT +0041522
002: A.1 07 07
IN +0353800
OUT +0484010
003: A.1 02
IN +0060211 A32
OUT +0121423
END:068 TOTAL LENGTH: 0242915
SQ : 001 SR : B2
IN
0UT +0052002
SQ
01.
02.
03.
NO 0030910
SP 2
SP 2
YES 0130210
SP 1
SP 2
NO 0061212
SP 2
SP 3
35
SN : 01
+0031001 CUT SP 1
CUT SP 1
EFFECT PAGE
COUNTER
TITLER T01 +0033020
GPI-001 IN +0033220
OUT +0033320